Legacy Motion Controllers - (not recommended for new designs) |
||
The motion controllers listed on this page are not recommended for new projects. They are listed here for the benefit of existing customers who still need to purchase them and obtain support. If you need a motion controller for a new project, please visit our Products page or see our product selection guide. ISA-bus Motion Controllers
| ||
|
DCX-AT 300 The DCX-AT 300 is a 1 to 6 axis legacy ISA-bus servo and stepper motion controller featuring multiple DSP processors on PMC's modular architecture. More... |
|
|
|
DCX-AT 200
The DCX-AT 200 is an economical 1 to 6 axis legacy ISA-bus servo and stepper motion controller which features a modular multi-processor architecture. More... |
|
|
DCX-PC 100
The DCX-PC 100 is a 1 to 8 axis legacy ISA-bus servo and stepper motion controller featuring on-board servo motor amplifiers. (Note: For a compatible replacement product, please see the DCX-PCI 100 motion controller and PMC Tech Note TN1050  (PDF 41KB)).
|
|
|
DC2-PC 100
The DC2-PC 100 provides 2 axes of servo control in a low-cost ISA-bus form-factor. Also optionally supports stand-alone operation via RS-232. More... |
|
|
VME-bus Motion Controllers
|
||
|
DCX-VM 300
The DCX-VM 300 is a 1-6 axis VME-bus servo and stepper motion controller featuring DSP processors and packaged in a VME-bus form-factor. More... |
|
|
|
DCX-VM 200
The DCX-VM 200 is an economical 1 to 6 axis VME-bus servo and stepper motion controller which features a modular multi-processor architecture. More... |
|
|
Stand-Alone Motion Controllers
|
||
|
DC2-STN 100
The DC2-STN 100 provides 2 axes of analog servo control and RS-232 serial communication in a stand-alone enclosure. More... |
|
